Coyote Point Systems Equalizer Bedienungsanleitung PDF herunterladen (Seite 3)

Coyote Point Systems Inc.

Installation and Removal

7. When the upgrade script is finished, it displays the message:

System reboot is required.

Reboot now (y/n)?

Type “y” and press Enter to reboot.

The upgrade is now complete. When Equalizer comes back up, log into the Administrative Interface. The Welcome

screen should indicate the new

Equalizer Version as well as the Virtualization Load Balancing version, as shown

in following screen.

Returning to the Previously Installed Version

To return to the version of Equalizer software that was running immediately prior to upgrading to the Equalizer VLB

Beta, do the following:

1. Log into the Equalizer console as

root and reboot the machine:

shutdown -r now

2. Watch the messages on the console as the system boots. When the prompt to select a partition appears, choose

the non-default partition and continue with the boot process.

Upgrading Over the Equalizer VLB Beta

When you upgrade over the Equalizer VLB Beta, the upgrade may stop if there are settings in the configuration file

that the version to which you are upgrading does not support. This will usually happen only when installing a

version that was released prior to the current version. If the upgrade stops due to a problem with the configuration

file, error messages will indicate the configuration settings that are not supported by the new version. You’ll need to

edit the configuration file and remove these settings before continuing.

Follow the process documented in the section “Manually Editing the Configuration File During an Upgrade”, in the

detailed upgrade instructions for Version 8, in the Software Upgrades section of the Coyote Point Support Portal

(coyotepoint.com/support.htm).

1 2 3 4 5 6 7 8

Keine Kommentare

Coyote Point Systems Equalizer Bedienungsanleitung Seite 3