Coyote Point Systems Equalizer Spezifikationen PDF herunterladen (Seite 445)

100

101

Perform Steps 4 and 5 on the

preferred primary

Equalizer to add failover flags and to

create a new peer definition for the backup.

You now need to configure the

preferred primary

Equalizer by adding failover flags and creating a peer on it for the

backup that you created in steps 3 and 4. You will need the peer signature from the backup that you retained in

step 4.

4. Log in to the Equalizer you will designate as the preferred primary and do the following:

a. Display the peer name of the preferred primary by entering:

b. Assign failover, peferred_primary flags to the preferred primary Equalizer by entering:

eqcli > peer name flags failover,preferred_primary,fo_config_xfer

c. Verify that the flags are correct by entering the show peer command again to display the

peer (preferred primary). The flags should display F/O, P/P, xfr beneath the Flags

heading. The fo_config_xfer is used on the local peer and not on the remote peer. If it

is enabled the primary peers on both systems will synchronized the configuration. When the

flag is changed for the local peer, it should be reflected in the remote peer on the other

system.

5. Now create a peer definition for the preferred backup on the primary Equalizer:

a. Enter the following:

eqcli > peer name signature signature flags failover

Substitute the signature of the preferred backup that you obtained in Step 4,

above.

b. Verify the new peer definition by entering:

eqcli > show peer

445

Equalizer Administration Guide

1 2 ... 440 441 442 443 444 445 446 447 448 449 450 ... 593 594

Kommentare zu diesen Handbüchern

Keine Kommentare

Coyote Point Systems Equalizer Spezifikationen Seite 445

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Equalizer Coyote Point Systems Equalizer