Coyote Point Systems Equalizer Spezifikationen PDF herunterladen (Seite 451)

100

101

Configuring Active/Passive Failover (GUI)

Perform Steps 1 and 2 on

both

Equalizer.

1. Perform initial system configuration on both units as outlined in "Networking Technologies" on page 78.

2. Configure VLANs and subnets on both units; they must be exactly the same as noted in "EQ/OS Version

10 Failover Constraints" on page 435.

Perform Step 3 on the

preferred backup

Equalizer to obtain the peer signature.

3. Log in to the GUI for the backup Equalizer using the procedures described in "Logging In" on page 192.

a. Click on a peer to be used as the preferred backup on the left navigational pane. The following

will be displayed:

b. Check the Failover flag.

c. Highlight and copy the failover Signatureof the preferred backup Equalizer. Copy the

signature to an electronic clipboard, notepad or whatever means available to save it.

Perform Steps 4 and 5 on the

preferred primary

Equalizer to add failover flags and to

create a new peer definition for the backup.

You now need to configure the

preferred primary

Equalizer by adding failover flags and creating a peer on it for the

backup that you configured in steps 3 and 4. You will need the peer signature from the backup that retained in step

4. Log in to the GUI for the preferred primary Equalizer using the procedures described in "Logging In" on page

192.

a. Configure the preferred primary peer and check the Failoverand preferred_primaryflags to

the preferred primary Equalizer as shown below.

451

Equalizer Administration Guide

1 2 ... 446 447 448 449 450 451 452 453 454 455 456 ... 593 594

Kommentare zu diesen Handbüchern

Keine Kommentare

Coyote Point Systems Equalizer Spezifikationen Seite 451

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Equalizer Coyote Point Systems Equalizer