Coyote Point Systems Equalizer Spezifikationen PDF herunterladen (Seite 521)

100

101

send a NULL response.]

If only some GeoSites report failed triangulation, and there are others that did not fail and that are not down, then

GeoSite selection will only include those sites that successfully completed ICMP triangualtion. [This is the same as the

Version 8.6 behavior.]

Adding a GeoCluster (CLI)

To add a GeoCluster using eqcli as follows:

1. Log in to eqcli as described in "Starting the CLI" on page 128.

2. Enter the following at the CLI prompt:

eqcli > geocluster gcname req_cmds

Deleting a GeoCluster (CLI)

Delete a GeoCluster using eqcli as follows:

1. Log in to eqcli as described in "Starting the CLI" on page 128.

2. Enter the following at the CLI prompt:

eqcli > no geocluster gcname

Viewing and Modifying GeoCluster Parameters (CLI)

To add a GeoCluster using eqcli as follows:

1. Log in to eqcli as described in "Starting the CLI" on page 128.

2. Use the parameter descriptions above and the command line sequences described in "GeoCluster and

GeoSite Instance Commands" on page 156 to view and modify GeoCluster parameters using eqcli.

Adding a GeoCluster (GUI)

When Envoy is first enabled, there are no GeoClusters defined. To add a GeoCluster:

1. Log in to the GUI(See "Logging In" on page 192).

2. Right click on the GeoClusters in the left navigational pane and the Add GeoCluster form will be displayed.

521

Equalizer Administration Guide

1 2 ... 516 517 518 519 520 521 522 523 524 525 526 ... 593 594

Kommentare zu diesen Handbüchern

Keine Kommentare

Coyote Point Systems Equalizer Spezifikationen Seite 521

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Equalizer Coyote Point Systems Equalizer